Product Catalog
Request Information
Master STAGES™ NOCOR E6 is a super-concentrated, barium-free, water-based emulsion rust inhibitor that will protect steel, cast iron, and other ferrous parts from in-plant corrosion for up to six months. Parts coated with NOCOR E6 have a soft, almost invisible film that is easily removed using mild cleaners.
Unit of Measure

Package Type

 N/A Tote

Appearance

 N/A Brown Liquid

Odor

 N/A Mild

Flash Point

 N/A > 300 ºF

Potential of Hydrogen (pH) by 5 Percentage (%) Volume

 N/A 8.5 to 10.0 pH

Volatile Organic Compounds

 N/A 133 g/L

BRIX Factor

 N/A 1.2

Applications

 N/A
  • Corrosion Inhibition
  • Dip
  • Flow coating
  • Low-pressure spray washing

Working Material

 N/A Cast Iron Copper Alloy Ferrous Metals Steels

Industry Focus

 N/A Automotive

Application Procedure

 N/A
  • NOCOR E6 must be diluted with water by the user. There are no special mixing requirements. DI or RO water will produce a more stable emulsion and better rust inhibition, but "soft" tap water may be used. The normal dilution range is from 4% - 16% product in water.
  • NOCOR E6 working baths should not be heated above 120°F as this will reduce its effectiveness. Drying with hot air up to 250°F produces good results.
  • Concentrations below 4% are not recommended.
  • NOCOR E6 must be allowed to dry completely prior to stacking or packaging parts and must be drained from blind holes and recesses.
  • Since carry over of cleaners into the NOCOR E6 bath can reduce resistance to wash-off, and so reduce protection, you should insert a plain water rinse between washing and NOCOR E6 application if possible.

Recommended Concentrations

 N/A 4.0 to 16.0%

Features and Benefits

 N/A
  • Environmental approvals are simplified because
  • NOCOR E6 is nitrite, barium, boron, phenol, and phosphate free NOCOR E6 is low foaming, for use in low-pressure spray washers and flow coating operations. Dip application is also a good way to apply this product
  • An excellent choice where both ferrous and/or copper alloy parts are being processed
  • NOCOR E6 has a moderate pH, is practically odorless, and is nonflammable for improved safety
  • Working concentration ranges from 4% - 16% which translates into much lower cost than traditional straight oil/solvent products
  • Free of: barium, borates, nitrites, phenols, and phosphate